To repair and space of drywall that has been damaged you’ll need sheet rock, a utility knife, fast dry-low mud joint compound, mesh tape for drywall, one inch galvanized drywall screws, a drill, drywall knife and a drywall sanding block. A drywall repair toolkit is easy. Cowl the tape and taper or feather” the perimeters of the brand new compound onto the surrounding wall surface (picture 5). Drywall compound needs to be utilized in a number of thin layers as a result of thicker layers are too difficult to smooth out and will eventually trigger cracking. Enable the textured compound to dry in response to the manufacturer’s directions, then prime and paint the floor.
To find out if the joint compound is completely dry, run a bit of sandpaper over the joint compound. When attainable, depart a number of inches of drywall at corners so you will not need to unfold taping compound onto adjacent partitions or ceilings and repaint them as properly! If the damage is limited to the drywall compound, merely take away all unfastened material and apply new compound.
Discard the drywall and remove all uncovered drywall nails or screws. (It’s not obligatory to reinforce the horizontal edges of the replacement drywall.) Safe the 2x4s to the drywall with drywall screws (picture 4). Set the brand new drywall into the outlet and secure to the 2x4s with screws. For those who’re patching tiny nail holes, you can cowl up the repairs by dabbing on touch-up paint with a soft fabric.
Reduce a bit of drywall into a square shape that is 2 inches bigger in width and top than the area to be repaired. First, twist a utility knife into the wall to carve away the joint compound from above a popped nail or screw. Before you paint a wall it’s a must to put together the surface, which inevitably includes patching. Use a 6-in.-huge putty knife and apply the compound as proven in the two pictures.
Trim the rough edges of drywall across the patch. Typically you will find a wire, pipe or duct (Photo 1). In that case, work carefully round them with a drywall or keyhole saw. All you have to do now’s prime the patch utilizing a drywall primer then paint the patch to match the present wall color. This is one time when it is handy to have a gap in the wall.